Configuration – Manual Probe (Prb) Select

 

The Manual Probe Select menu option allows the user to select a specific probe to use.  The probe selected will override the automatically selected probe. If in AUTO mode, the system will continue to select the configured probe when the deviation band is exceeded.  To run continuously in MANUAL mode, you must first select the MANUAL mode from the Probe Select Mode menu (described above).  To select a specific probe, press the ENT key.  The right digit will begin to flash.  Pressing the up arrow key will reset the value to 1. Press the up arrow key until the desired probe is reached.  Once the desired probe has been selected, press the ENT key to set the value.  Pressing the NEXT key will display the initial display screen.  Pressing the PREV key will display the Probe (Prb) Select Mode menu screen.

 

Example – The following example will show how to set the manual probe selection from a value of 1 (Probe 1) to a value of 2 (Probe 2). 

 

Press the ENT key. The 1 in Probe 1 will begin flashing.  Press the up arrow key twice so that Probe 2 is displayed.  Press the ENT key to set the value. 

 

Note about Manual Probe Selection – Although the numbers will cycle from 0 to 9, the only valid values are 1 and 2.  Any value entered higher than 2 will be set to the last set value by default.