Configuration – Deviation Band

 

The Deviation Band menu screen will display the number of millivolts that the deviation band alarm is set for (default = 10 mV). Pressing the ENT key will enable the user to modify the deviation band value.  Once the ENT key is pressed, the rightmost number will begin flashing.  Pressing the up arrow key will reset the value to a 1.  Pressing the up arrow key again will increment this value by one.  Enter the new value as desired.  Pressing the ENT key will set the entered value.  Pressing the CLR key will reset the value to the last set value.  Pressing the NEXT key will display the Alarm Delay menu screen.  Pressing the PREV key will display the initial display.

 

Example  - The following example will show how to set the deviation band from a value of 50 mV to a value of 35 mV

 

.  Press the ENT key.  The 0 in the 50 will begin flashing.  Press the up arrow key three times so that a 3 is displayed.  Press the left arrow key once so that a 30 is displayed.  Press the up arrow key five times so that a 35 is displayed.  Press the ENT key to set the value. 

 

Note about Deviation Band – the valid range of values for the deviation band is 0 to 50 mV.  Any value entered over 50 mV will be set to the last set value by default.