Adjust Setpoint

To display the current setpoint, press .  This will bring up the setpoint screen. 

 


Use the numeric keypad to enter the desired setpoint.  Press to accept changes, or press to return to the main screen without saving changes.

 

 

NOTE: Setpoint can also be adjusted using one of the following methods:

 

  1. Remote analog signal (4-20mA)

  2. Remote digital signal with Modbus serial communications over RS485 – Register 18

  3. Web interface (refer to Main Screen).

    4.  

    Note: The remote setpoint setting overwrites any manual setting. Therefore, if manual control of setpoint is desired, ensure that there is no external signal overwriting the manual setting.