Initial Network Configuration

 

This section is intended for use by persons familiar with Ethernet network setup.

 

In order to work correctly, the eFlo unit must be properly configured for the network to which it is connected.

 

NOTE:  By default, the IP address of the eFlo unit is static, and Dynamic Host Configuration Protocol (DHCP) is disabled.  These settings can be adjusted through SSi’s nLocateIP software (see below), the web interface (Using the Web Interface), or through the eFlo keypad. 

 

If you already know the IP address of the web interface, skip to the Web Interface. The network configuration is described in this section.

 

The eFlo unit will use a default IP address of 192.168.1.200. If the unit is using the default IP address, that IP address can be used to access the web interface (for more information on the web interface, refer to the Web Interface section.

 

The IP address of the unit can also be found by using SSi’s nLocateIP software. This method is described in the following subsection.