5.2.20 Passcodes

Passcodes are required to enter both Operator Level 2 and Configuration Level. They are set to default values during manufacture but they can be re-configured using P76 and P77.

 

P76

Select P76 to configure Level 2 Pass code. Default value: 2.

The passcode required to enter Level 2 can be set in the range 0 to 9999.

 

In the case of level 2 passcode being set to 0, it will not be necessary to enter a passcode to access level 2 and the controller will enter level 2 directly.

 

Note:

In FM approved versions 816L 808L and 804L, P76 cannot assume the 0 value, that is password disabled – it can be set in the range 1-9999 only.

 

☻ Make a record of any changes to the passcode

 

P77

Select P77 to configure Configuration Level Pass code. Default value: 4.

The passcode required to enter Configuration Level can be set in the range 0 to 9999.

 

In the case of the configuration level passcode being set to 0, it will not be necessary to enter a passcode to access configuration level and the controller will enter ConF directly.

 

☻ Make a record of any changes to the passcode