1.4.1 Panel Mounting the Controller

Prepare a cut-out in the mounting panel to the size shown in section 1.4.2. If a number of controllers are to be mounted in the same panel observe the minimum spacing shown in section 1.4.3.

 

Carefully remove the panel retaining clips from the sleeve using figures or a small screwdriver.

 

To achieve IP66 sealing, make sure the gasket is fitted behind the front bezel of the controller.

 

Insert the controller through the cut-out.

 

Spring the panel retaining clips back into place. Secure the controller in position by holding it level and pushing both retaining clips forward.

 

Peel off the protective cover from the display.

 

If the panel retaining clips subsequently need removing, they can be unhooked from the side with either your fingers or a screwdriver.