-
Click
in the TCS column to select and deselect the desired T/Cs. -
Click
in the CERT# column to edit information for this Wire Cert. Here you can enter info for: Certification #, Wire Serial #, TC Type, Cert Date, Due Date, Calibrated By, TC Gauge, and Degree Type.
You can also enter any necessary corrections. Click
to generate a new correction. Enter in the Temperature and Correction information. Click 
to delete the highlighted correction, and click 
to re-order the existing correction. -
Click
to select pre-existing wire cert information.
Certs Panel
Wire Certs Selection
Click “Use Wire Certs” to select if wire certs will be used in this template.
Click to enter new Cert information. For each cert:
Instrument Cert Selection
Click to select if instrument certs will be used in this template.
Click to Edit Cert information (this includes entering new info).
Enter the Instrument Serial #, then click to edit or enter Board Cert information. On the Board Certs window, click to add a new Board Cert. Enter the relevant Metadata and Corrections, then click 
to save.
Click to delete the highlighted Cert, and 
to duplicate.
Click to load previously saved instrument cert information. Click to highlight an instrument from the list (sortable by Serial # or Due Date). This will display the Board Certs for this Instrument. From here you can click to edit Cert info (this may require a passcode) or 
to view Metadata and Corrections without editing.
Click the “Use Selected” button to use a highlighted Instrument.
Manual Instrument Offsets Selection
(this option is only available if Instrument Certs are not selected)
Click “Set Manual Instrument Offsets” to select if Manual Instrument Offsets will be used in this template.
Click to manually enter corrections for TCs as necessary. Click “OK” to save or “Cancel” to discard entered info.