Minimum Millivolt condition (0 = disabled)

This determines the behavior of the RGA when the minimum millivolts value is reached. Two settings are available:

• Also stops pump. When this setting is selected, the sample pump will be stopped if the pump is set to “Auto” mode (see the Pump Control section on page 1), and COF/PF adjustment will be stopped.

• Only inhibits adjust and control. When this setting is selected, COF/PF adjustment will be stopped, and the sample pump will be allowed to run.

To use this feature, the instrument should be communicating with an instrument that can provide real-time probe millivolt data.  This is another feature that is intended to prevent the analyzer from pulling a bad sample and potentially damaging the sensors.