WARNINGS

 

RETAIN ORIGINAL PACKAGING. PROPER PACKAGING IS REQUIRED WHEN RETURNING PGA FOR CALIBRATION OR REPAIR. DAMAGE CAUSED BY IMPROPER PACKAGING IS NOT COVERED UNDER THE WARRANTY.

 

 

Shipping the Instrument Back to Super Systems

When returning the PGA3500 to SSI for calibration or any other service, it must be properly protected during shipment.  The best method of packaging the instrument is in its original packaging which includes custom-fit foam.  For this reason, the original packaging should be retained.  If the original packaging is not available, the instrument should be shipped in a suitably sized cardboard box with at least 4” of solid padding on each side of the instrument (not packing peanuts). 

 

In the event that the PGA3500 is returned to Super Systems with improper packaging, we reserve the right to charge for replacement custom foam and a new box instead of risking damage to the instrument during reshipment. 

 

Super Systems will not be responsible for damage caused by improper packaging.

 

IT IS THE RESPONSIBILITY OF THE OPERATOR TO ENSURE THAT THE GAS BEING SAMPLED DOES NOT PRODUCE ANY CONDENSATION. SENSOR DAMAGE DUE TO MOISTURE WILL VOID THE WARRANTY

 

Moisture and Condensation

Depending on the composition of the gas being sampled, it is possible that condensation could occur in the sample tubing.  This is not likely in a properly operating endothermic atmosphere, however condensation can occur in either a poorly operating endothermic or any exothermic atmosphere.  Do not leave the PGA3500 unattended for long periods of time unless you are confident that the gas being sampled will not condense in the sample lines.  If moisture gets inside the instrument it will result in permanent damage the sensors, which is not covered under the warranty.