Wiring Connections

Terminal blocks inside the instrument are available for the following purposes:

 

Each terminal block is numbered according to the included electrical drawing.  Knockout holes in the enclosure have been provided to simplify wiring connections.  Knockouts are located on the bottom of the enclosure.  Additional or alternate locations can be added as needed.  Please note that due to the potential for electrical interference, it is recommended that communication wires not be run in parallel to AC power wires.

 

The right side of the enclosure also contains two Ethernet ports, one USB A port (Host) and one USB B port (Client).  These can be used to communicate to the MZA 6010.  For detailed information on the use of these ports, please see the section of this manual, Communications and Source Setup. Appendices A and B show the wiring connections.