Installing and Removing the Battery Pack

The DPL4000 is supplied with a rechargeable battery pack.  It is also possible to power the instrument using four (4) “AA” 1.5V alkaline batteries.  To use the alkaline batteries, you will need to install the supplied metal contact plate at the base of the battery housing.

1.    Unscrew the back plate of the indicator.

2.    Remove the old batteries. If a rechargeable battery is installed, remove the black connector by gently pulling up on the wires.

Figure 1    Installing the Battery Pack

 

3.    Connect the black connector of the new rechargeable battery pack. Make sure the red and black wires are on the upper edge of the connector. Do not push the connector with any conducting material.  If using alkaline batteries, the metal contact plate will need to be inserted if it is not already present.

4.    Close the back plate, and tighten the screw.

5.    Charge the battery before use.