Custom Curves

The Custom Curves menu option will allow the user to set up the variables for the curves.  Curves are applied when the user wants to use a non-linear compensation to the input, such as in vacuum areas.  There are a maximum of seven curves.

The Interpolation Type can be one of the following:

    None

    Linear

The mV 1 through mV 32 can be within the range of –32768 to 32767.

The Offset 1 through Offset 32 can be within the range of –32768 to 32767.

Note:  This is where the user will create the custom curve that can be applied to the inputs through the Range Setups menu option.  See the Range Setups section for information on how to apply a curve to an input.

An example of a non-linear curve is for a 0 to 1V span (0 to 1000 mV).  If the mV is 0, then the offset is 0.  If the mV is 200, then the offset if 400, etc.