Client Instrument Setup

 

** All devices on the same Client port must utilize the same protocol

** An address of zero (0) will disable the instrument** Some controllers (AC20 for example) can provide dual functions (atmosphere and events) and must have the same address assigned for both.

 

Clicking on the “Value” field for any instrument will allow the user to select the Client instrument.

 

Instrument:

This value will allow the user to select the Client instrument type.

 

List of Instruments:

The following is the list of instruments available as Client instruments:

SSi AC20           

[A]Yokogawa 750       

[A]Honeywell UDC3300        

[A]Dualpro LP1 Modbus        

[A]Dualpro LP2 Modbus        

[A]Dualpro LP1 MMI        

[A]Dualpro LP2 MMI        

[A]Eurotherm 2404        

[A]Eurotherm 2500        

[A]Carbpro v3.5            

[A]Carbpro v3.0            

CarbPC                

[A]9200 LP1           

IR Base                

MGA                

SSi 7EK                

[T]Yokogawa 750        

[T]Honeywell UDC3300        

[T]Dualpro LP1 Modbus        

[T]Dualpro LP2 Modbus        

[T]Dualpro LP1 MMI        

[T]Dualpro LP2 MMI        

[T]Eurotherm 2404        

[T]Eurotherm 2500        

Unipro v3.5            

Unipro v3.0            

[T]Carbpro v3.5 Client        

[T]Carbpro v3.0 Client        

10Pro                

Dualpro IN C            

[T]9200 LP1            

[T]9200 LP2            

[T]9200 LP3            

9100 LP2            

Eurotherm 2704 LP1        

Eurotherm 2704 LP2        

Eurotherm 2704 LP3        

VC Base 1            

VC Base 2            

VC Base 3            

VC Base 4            

AIPC                

SSi 7SL                

SSi Flow Board            

UMC800 LP1            

SSi Quad AO1

SSi Quad AO2

SSi Quad AO3

SSi Quad AO4

Yokogawa UT350

Yokogawa 750 Lp 2

Yokogawa UP350

Honeywell DCP551

Ascon 08

SSi AC E

Yokogawa 750E

Mod Mux

Dualpro E Modbus

Dualpro E MMI

Carbpro E v3.5

Carbpro E v3.0

Eurotherm 2500

SSi 8-8

SSi 9200 E

Micrologix PLC

MCM Module

PLC5 DF1

SLK DF1

 

Address:

This value allows the user to select the address that corresponds with the controller selected, with a range of 0 to 249.

Port:

The options for this field can either be Client 1 or Client 2

Client 1 – terminals 5(-), 6(+)

Client 2 – terminals 22(+), 23(-)

RS-232

 

IMPORTANT!   The 9220 will generate a programmer alarm if communications with a Client instrument are lost. The alarm will contain information on the Client instrument number to which communications were lost and will be displayed in Configurator and on the touch screen’s main status screen. (If the alarm is connected to a relay and the relay is wired to an audio device, an audible alarm will be generated.)