Port Setup

 

Warning: Changes to this screen should not be made without consulting SSi at 513-772-0060. This screen will show the Ethernet and RS-232/RS-485 communications information for the 9215 controller.

 

Note about ADAM module support: Communications with ADAM analog input modules manufactured by Advantech are not supported as of 9215 firmware revision 2.34. To determine the firmware version of your 9215 instrument, use the About option in the main menu.

 

Host 232 Baud This will set the baud rate for RS-232 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  The list of options is: 1200        14400        57600        460800 2400        19200        76800        921600 4800        28800        115200 9600        38400        230400   Host 232 Mode This will set the mode for RS-232 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  The list of options is: Modbus/no PLC Modbus master/PLC

 

Host 485 (3,4) Baud

This will set the baud rate for RS-485 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  The list of options is:

1200        14400        57600        460800

2400        19200        76800        921600

4800        28800        115200

9600        38400        230400

 

Host 485 (3,4) Mode

This will set the mode for RS-485 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  This setting is fixed at Modbus.

 

Host 485 Address

This will set the address for RS-485 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  The range is 1 – 247.

Client 1 485 (5,6) Baud

This will set the baud rate for Client 1 communications.  The list of options is:

1200        14400        57600        460800

2400        19200        76800        921600

4800        28800        115200

9600        38400        230400

 

Client 1 485 (5,6) Bits

This will set the data bits, parity, and stop bits (in that order). The list of options is:

8, none, 1

8, odd, 1

8, even, 1

8, none, 2

 

Client 1 485 (5,6) Mode

This will set the mode for Client 1 communications.  This list of options is:

Modbus

Yokogawa

Modbus Host

 

Client 2 485 (22,23) Baud

This will set the baud rate for Client 2 communications.  The list of options is:

1200        14400        57600        460800

2400        19200        76800        921600

4800        28800        115200

9600        38400        230400

 

Client 2 485 (22,23) Bits

This will set the data bits, parity, and stop bits (in that order). The list of options is:

8, none, 1

8, odd, 1

8, even, 1

8, none, 2

 

232-2 Port Baud

This will set the baud rate for RS-232 communications.  This is necessary if the Touchscreen will be communicating through the Com ports.  The list of options is:

1200        14400        57600        460800

2400        19200        76800        921600

4800        28800        115200

9600        38400        230400

 

PLC Type

The list of options is:

Micrologix Modbus

MCMmodule Modbus

DF1 PLC5

DF1 Slik

Passive