This menu option will allow the user to enter offsets for the auxiliary inputs and apply any correction curves as needed.    The offset can be in degrees + or -, and it is typically used to compensate for incorrect T/C wires. 

Enable Offsets for SSi AIB

This will enable the use of offsets for any analog input boards.  The options are: Yes or No.

Input 1 – Input 40

This is where the actual offsets will be entered for each input.  The range is -50.0 – 50.0.

Input 0 Correction – Input 39 Correction

This is where any correction curve can be applied for each input.  Note – The input names for the corrections are offset by 1, so Input 0 is actually Input 1, Input 39 is actually Input 40, etc.  The options are: Not Used, Curve 1, Curve 2, or Curve 3.