Program Edit

Selecting Program Edit displays another screen, which asks the operator to enter a program number to be edited. Enter 0 to edit a blank program.  To erase/delete an existing recipe/program you need to save it as Program Zero (0).  Program 0 is a “NO-OP” program.   Depending on the 9210’s security setup and current Login status, the user may be first prompted to enter a pass code before being allowed to enter a program number to edit.

 

When you enter a number for a stored program and push the Enter key the program steps are displayed. Using the up and down arrow keys allow the user select the step in the existing program to edit. Move the cursor to that step and press the Enter key. The next screen to pop up will show the step’s parameter and its value.

 

NOTE: A list of Op-Codes appears in Chapter 6 of this manual.

Example:

Parameter	Value
Opcode	SOAK
Time (hh:mm)	3:45

 

Highlighting the Opcode line and pressing the Enter button brings up a screen that shows all of the possible Opcodes. Use the Up or Down arrow keys to select the Opcode that you want to use for the program step that you are editing and press the Enter key.  To change the Time option, highlight the line and press the Enter key. The next screen is the “Time Edit” screen. If you wish to change the hour, press the Hour button in the upper right-hand corner. If you want to change the minutes press the Min button. The next screen that pops up in both cases is a numeric keypad. Enter the number of hours or minutes that you wish to permanently change the recipe to and press the Enter button. If you DO NOT wish to make any changes press the Esc button.

 

Press the Set button to save the changes in the program.  Notice that the time has been changed on the program segment that you were editing. If you wish to save this change, press the Save button. You will notice that a numeric keypad pops up and asks you to enter the number of the program that you wish to save. It defaults to the program number that you were editing. If this is the program that you wish to save the change, press the Enter key. If you wish to save this as a new program, press the Clr button on the numeric keypad, enter the number of the recipe that you want to save it as and press the Enter button.  At this point, Program Editing is done and the display returns back to the Menu screen.

 

NOTE: See Chapter 6 of this manual for some sample programs.